Vibration Anti Bark Dog Training Collar Remote Control

Remote training collar with LCD display.

Patented design.

For mild-mannered to stubborn disposition dogs.

Easy to use and ergonomic transmitter.

Rheostat dial allows for gradual adjustment in stimulation intensity.

With no jumps between 0 and 100 levels.

300 meter range.

Static and vibration mode.

No external antenna on collar.

Easily visible LCD screen displays level of stimulation.

Over 3,000 different identity codes to prevent conflicts with other e-collars.

Three bar battery life indicator on transmitter.

Limited lifetime warranty

100 Levels of Static Stimulation and 100 Levels of Vibration

With LCD Monitor Display and Belt-Clip Designed Remote for One Dog

Vibration Anti Bark Dog Training Collar Remote Control Features:

-.100 levels of vibration.

-.100 levels of static (optional). You can gradually increase the vibration or static shock level from 1 to 100 as you wish. Level 1 is the most soft level and level 100 is the opposite, you should change the level depending on the endurance and reaction of your dog in response to the stimulation.

-.The levels can be altered by use of up and down button.

-.A tone button activates a tone on the receiver.

This system is used for only 1 receiver.
-.The receiver will TURN OFF if it is unused for 4 minutes.

-.Any movement will activate the receiver into STANDBY MODE.

-.The transmitter will go into STANDBY MODE if there is no operation after 20 seconds and turn off after 2 minute.

-.Adjustable belt length, maximum diameter of 18cm, fit the dog with neck size from 1 to 18 inches. Two pairs of metal prong (short/long) to suit dogs with varied fur thickness.

User Manual for Transmitter:

-.To install the batteries, open the battery cover, which is at the back of the transmitter.

-.Install the battery (2 x 4LR44/ 6V) in the transmitter and ensure the polarity is correct.

-.The transmitter will be TURN ON automatically.

-.Press the buttons one by one - the LCD images will change.

-.Press the up and down buttons on right hand side to set level.

-.The LED light can be used for giving training signals.

-.The transmitter will go into STANDBY MODE if not operated for 20 seconds and will TURN OFF if not operated for 2 minutes.

-.In STANDBY MODE, press any button (except LED light button) to wake it up.

-.To TURN ON the transmitter, hold mode button for at least 5 seconds.

User Manual for the Receiver and Code:

-.To install the batteries

-.Remove the cover

-.Install the batteries (2xAAA 1.5V), make sure the polarity is correct

-.There is a beep right after installing the batteries in the receiver

-.Go to the transmitter and choose 1 or 2 channel to encode by pressing the channel button 1/2 in the transmitter

-.Then press the LAUNCH button on transmitter immediately

-.The receiver will beep - it is now encoded to the transmitter

-.Replace cover and tighten metal probes

Specification-Collar:

Length:

43mm Height: 68mm

Width:

38mm
Collar length adjustable from 35cm to 58cm
Weight:

56g (module + battery)
Power:

2 x 1.5V AAA battery (included)

Specification-Handset:

Length:

25mm Height: 83mm

Width:

45mm
Weight:

40g (with battery)
Power:

2 x 4LR44/ 6V (included)
LED signal light and illumination at night

The sound function for attracting attention